The complete range of C-Bus products have been designed and developed
in Australia to meet all commercial, industrial and residential requirements.
All modules are available as off the shelf products with extensive back
up and after sales service direct from the manufacturer.
5031N
One Gang Key Input |
Consists of one positive feel tactile switch with a red light emitting
diode recessed in the switch. The switch can be programmed to provide
on/off, dimmer or timer functions. |
 |
|
5032N
Two Gang Key Input
|
Consists of two positive feel tactile switch with a red light emitting
diode recessed in the switch. The switch can be programmed to provide
on/off, dimmer or timer functions. |
 |
|
5034N
Four Gang Key Input
|
Consists of four positive feel tactile switch with a red light emitting
diode recessed in the switch. The switch can be programmed to provide
on/off, dimmer or timer functions. |
 |
|
5100PS
Power Supply, 320mA
|
Provides safe extra low voltage (36V d.c.) to the C-Bus. The power
Supply is capable of supporting typically 18 C-Bus units (Key Input
Units, Dimmer Units etc...) Multiple Power Supplies may be paralleled
to support more C-Bus units. |
 |
|
5104R
Four Channel Relay
|
Allows control of four independent loads, up to a maximum 20A. Individual
channel load rating of 10A. Switched active outputs require all four
loads to operate from the one phase. |
 |
|
5104D4750
Four Channel Dimmer
|
Allows control of four independent loads, up to a maximum 3000VA.
Individual channel load rating of 750VA. Switched active outputs require
all four loads to operate from the one phase. The Dimmer Unit is capable
of controlling incandescent lighting, dimmable ballasted florescent
and low voltage lighting (via control of the primary current in a
step down transformer. |
 |
|
5104AM
Analogue Output, 0-10V
|
Provides the means to control four independent loads on the C-Bus
network over a control voltage range of 0-10V. The unit allows control
over OEM products including dimmable fluorescent lamp ballasts. The
output voltages are optically isolated from the C-Bus network for
safe operation. |
 |
|
5031PE
Light Level Sensor
|
Used to measure ambient light levels in the range of 20 to 3000
lux. Ambient light is measured and output devices such as Dimmer Units
can be controlled to maintain constant illumination in a given area,
under varying conditions. |
 |
|
5751
PIR Occupancy Sensor
|
Detects passive infa-red energy for control of any number of independent
circuits, including lighting and security systems. The light level
is adjustable from the front of the unit and can be used to disable
the Occupancy Sensor. Time settings are adjustable from 1 second to
18 hours, in one second increments. |
 |
|
5100B
Network Bridge
|
The Network Bridge allows the connection between two C-Bus networks,
for data communication while maintaining optical isolation between
the networks. The unit is also used to restore logic levels over long
continuous C-Bus cable runs. Network Bridges should be used when more
than 100 C-Bus units are used in any network. The use of Network Bridges
allows the C-Bus system a virtually unlimited expansion. |
 |
|
5100PC
PC interface
|
Provides the medium for an external PC to communicate with the C-BUs
network, including monitor and control functions. It can be used to
program all other C-Bus units and generates the system clock for synchronised
data communications. |
 |
